MTP-8 to MTP-8 UPC Trunk Cable, Male, 32 Fibers, OM3, Type B

This 32 Fibers (Base-8) MTP® Elite Male trunk assembly is built for backbone cabling between racks, rows and distribution frames. OM3 50/125μm fiber, Plenum (OFNP) jacket and factory installed pulling protection make it a one-pull replacement for hours of field termination work.

Standard lengths are 1m (3ft), 3m (10ft), 5m (16ft), 7m (23ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft), 30m (98ft) and 40m (131ft). Because we are the manufacturer, any other length between or beyond these steps can be produced on request, with your choice of jacket color, labeling and packaging.

Product Highlights

• MTP® Elite Male (Pinned) to MTP® Elite Male (Pinned), 32 Fibers (Base-8)
• OM3 50/125μm, bend insensitive fiber
• Insertion loss ≤0.20dB, return loss ≥27dB
• Type B polarity
• 5.5-5.6mm Plenum (OFNP) round cable
• Minimum bend radius 7.5mm
• Ten standard lengths from 1m (3ft) to 40m (131ft), custom lengths built to order

Typical uses include backbone links between the main distribution area and equipment rows, vertical risers between floors, and inter-cabinet trunks in large data halls. The 32 Fibers (Base-8) construction concentrates the equivalent of many duplex jumpers into a single assembly, which is exactly what high density spine and leaf cabling needs. Pre-termination cuts installation time dramatically compared with field splicing.

The trunk uses a double jacket design: a rugged outer sheath protects the whole bundle, while each breakout leg keeps its own jacket and numbering. Base-8 and Base-12 constructions are available depending on the fiber count. Polarity follows the Type shown in the table, and pulling eyes or mesh grips can be fitted for installation.

Ordering is simple: send us 32FMTPOM3 and your required lengths and quantities, and we return a factory quote the same working day. The 1m (3ft) version is the standard model; Small trial orders are welcome before you commit to a full project rollout.

Most orders leave our facility within a few working days. Courier, air freight and sea freight are all available, and we are happy to hand goods to your nominated forwarder in China.

Every MPO/MTP assembly leaving our factory is 100% tested for insertion loss and return loss, with end face geometry checks on the multi-fiber ferrules. Controlled polishing keeps the loss budget stable across the whole batch, which matters when several mated pairs sit in one link.

Each assembly is coiled, capped and sealed in an individual bag, then packed into foam lined export cartons. Test reports can be attached per unit or per batch, and carton marks follow your shipping instructions.