MTP-8 to MTP-8 UPC Trunk Cable, Female, 96 Fibers, OM4, Type B

High fiber count MTP® Elite Female trunk cable with 96 Fibers (Base-8), OM4 50/125μm and Plenum (OFNP) jacket. The double jacket construction protects the breakout legs during installation, and every leg is labeled and tested before the cable leaves our factory.

Standard lengths are 1m (3ft), 3m (10ft), 5m (16ft), 7m (23ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft), 30m (98ft) and 40m (131ft). Because we are the manufacturer, any other length between or beyond these steps can be produced on request, with your choice of jacket color, labeling and packaging.

Product Highlights

• MTP® Elite Female (Non-Pinned) to MTP® Elite Female (Non-Pinned), 96 Fibers (Base-8)
• OM4 50/125μm, bend insensitive fiber
• Insertion loss ≤0.20dB, return loss ≥27dB
• Type B polarity
• 9.0mm Plenum (OFNP) round cable
• Minimum bend radius 7.5mm
• Ten standard lengths from 1m (3ft) to 40m (131ft), custom lengths built to order

Backbone cabling is where mistakes cost the most, so this trunk is built and verified entirely in the factory. The 96 Fibers (Base-8) construction concentrates the equivalent of many duplex jumpers into a single assembly, which is exactly what high density spine and leaf cabling needs. It arrives with test results, labeled legs and the correct polarity for your panel layout.

The trunk uses a double jacket design: a rugged outer sheath protects the whole bundle, while each breakout leg keeps its own jacket and numbering. Base-8 and Base-12 constructions are available depending on the fiber count. Polarity follows the Type shown in the table, and pulling eyes or mesh grips can be fitted for installation.

Ordering is simple: send us 96FMTPOM4 and your required lengths and quantities, and we return a factory quote the same working day. The 1m (3ft) version is the standard model; Small trial orders are welcome before you commit to a full project rollout.

Our engineering team handles custom MPO/MTP assemblies daily. If the standard configuration does not match your link design, send us the requirement and we will build exactly what your network needs at factory-direct cost.

Standard configurations normally ship within a few working days by DHL, UPS, FedEx, TNT or EMS. For project quantities we arrange air or sea freight, and we can ship on your own courier account or deliver to your appointed forwarder.

Each assembly is coiled, capped and sealed in an individual bag, then packed into foam lined export cartons. Test reports can be attached per unit or per batch, and carton marks follow your shipping instructions.