Customized MPO-16 Jumper, 16F, OM4

This Customized MPO-16 Jumper, 16F, OM4 MPO Female/Male with Offset Key jumper is factory terminated and fully tested in our own facility, built on OM4 50/125μm fiber with a Plenum (OFNP)/LSZH jacket. It is designed for high density patching inside data center cabinets, where pre-terminated cabling saves hours of field splicing and keeps polarity under control from day one.

Available lengths are 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft) and 30m (98ft). We can also produce any intermediate or longer length to order, with your choice of labeling and packaging.

Product Highlights

• MPO Female/Male with Offset Key to MPO Female/Male with Offset Key,
• OM4 50/125μm, bend insensitive fiber
• Insertion loss ≤0.35dB, return loss ≥45dB
• Straight Through/Crossover/Cross Pair polarity
• Plenum (OFNP)/LSZH
• Minimum bend radius 7.5mm
• Stock lengths from 1m (3ft) to 30m (98ft), custom lengths on request

Use this jumper anywhere a short multi-fiber connection is needed: panel to equipment, cassette to cassette, or switch to switch within a row. Because it arrives polished and tested, the installer only needs to route and connect it.

The same jumper can be produced with different polarity and gender combinations. Male connectors carry guide pins for direct module connection, while female versions are used at panels. Polarity A, B and C are all standard for us, and our engineers can check your link diagram if you are unsure which one to order.

To order, quote 16FMPOOM4 together with the length and quantity you need. Private labeling, custom packaging and project specific documentation are all handled in-house.

We have manufactured fiber optic assemblies since 1995. MPO and MTP cabling is one of our core lines: fiber counts from 8 to 144, single mode and multimode, UPC and APC polish, trunk, jumper, harness and breakout formats. Send your drawing and we turn it into a ready to install assembly.

Every cable is protected with dust caps and individual packaging before being boxed for shipment. Batch test reports and your own part number labels can be included in each bag.

Our test routine covers insertion loss, return loss and ferrule end face inspection on every assembly. Because testing is done in-house, custom variants receive exactly the same verification as standard models.