Customized MTP-12 Armored Trunk Cable, 12-144F, OS2

High fiber count MTP® Elite Female/Male trunk cable with 12-144 Fibers (Base-12), OS2 9/125μm and Plenum (OFNP)/LSZH jacket. The double jacket construction protects the breakout legs during installation, and every leg is labeled and tested before the cable leaves our factory.

Available lengths are 2m (7ft), 3m (10ft), 5m (16ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft) and 30m (98ft). We can also produce any intermediate or longer length to order, with your choice of labeling and packaging.

Product Highlights

• MTP® Elite Female/Male to MTP® Elite Female/Male, 12-144 Fibers (Base-12)
• OS2 9/125μm, G.657.A1
• Insertion loss ≤0.35dB (0.15dB Typ.), return loss ≥65dB
• Type A/Type B/Type C polarity
• Plenum (OFNP)/LSZH
• Minimum bend radius 10mm
• Stock lengths from 2m (7ft) to 30m (98ft), custom lengths on request

This trunk is designed for permanent backbone positions: between patch panels, from the core to aggregation rows, or between buildings on a campus. A 12-fiber MPO interface carries 8 active lanes for 40G SR4 and 100G SR4 links, leaving the remaining 4 fibers dark, exactly as the MSA wiring specifies. Every breakout leg is numbered, which simplifies documentation and troubleshooting.

The trunk uses a double jacket design: a rugged outer sheath protects the whole bundle, while each breakout leg keeps its own jacket and numbering. Base-8 and Base-12 constructions are available depending on the fiber count. Polarity follows the Type shown in the table, and pulling eyes or mesh grips can be fitted for installation.

Ordering is simple: send us AM-XXFMTPSMF and your required lengths and quantities, and we return a factory quote the same working day. Small trial orders are welcome before you commit to a full project rollout.

We have manufactured fiber optic assemblies since 1995. MPO and MTP cabling is one of our core lines: fiber counts from 8 to 144, single mode and multimode, UPC and APC polish, trunk, jumper, harness and breakout formats. Send your drawing and we turn it into a ready to install assembly.

Every MPO/MTP assembly leaving our factory is 100% tested for insertion loss and return loss, with end face geometry checks on the multi-fiber ferrules. Controlled polishing keeps the loss budget stable across the whole batch, which matters when several mated pairs sit in one link.

Products are packed in anti-static or PE bags with connector dust caps fitted, then boxed in sturdy export cartons. Custom labels, barcodes and carton markings are available on request.