Generic DW2-QSFP100G80-2122 Compatible 100G QSFP28 Transceiver Module

Product Highlights

• Compatible alternative to Generic DW2-QSFP100G80-2122
• 100G connectivity at 100Gbps (2x50G)
• Optical wavelength: 1560.61nm,1559.79nm
• Specified reach: 80km with EDFA and TDCM
• Duplex CS/UPC / SMF interface
• Digital diagnostic monitoring: Supported
• Operating temperature: 0 to 85°C (32 to 185°F)

Specifications

Applications and Optical Link Design

Use this module for equipment interconnection over the specified single-mode fiber plant, including enterprise backbone, campus, metro or data-center interconnect links according to its rated distance. Confirm that both ends use the same optical standard and wavelength plan, and allow for connector, splice and patch-panel loss within the stated power budget.

Before deployment, check the host port type, supported data rate and firmware requirements. The 100G interface configuration must match the remote equipment; sharing a QSFP28 housing alone does not make two transceiver types interoperable.

Wavelength-selective links require the exact channel plan at both ends. Confirm that filters pass 1560.61nm,1559.79nm, then include their insertion loss in the 80km with EDFA and TDCM power budget. A nearby channel is not a substitute for the specified wavelength.

Generic Compatibility and Factory Testing

Compatibility testing for DW2-QSFP100G80-2122 combines identification with a live link and available transmit, receive and alarm information. Connector condition is inspected separately. Equipment model, hardware revision and software release can be reviewed before dispatch where platform behavior is uncertain.

Optical Acceptance, Diagnostics and Handling

For this model, the specified transmit-power range is -1~4dBm; the stated optical power budget is 12dBm. During commissioning, record the host diagnostic readings after the link has stabilized and compare them with those limits. DOM values are useful operational indicators, but they do not replace calibrated optical measurements when a link is marginal. Investigate unexpected loss through connector inspection, cleaning and a channel measurement before replacing the module. Diagnostic monitoring is listed as Supported. Before every insertion, keep dust caps in place until the patch lead is ready, avoid touching the optical end face and use an appropriate inspection and cleaning procedure. Do not look into an active optical interface.

Interoperability and Host Configuration

Check three layers before deployment: host acceptance of the module identity, port support for the stated rate, and a matching optical standard at the remote interface. For breakout operation, confirm lane configuration too. Similar-looking cages can behave differently across speeds and firmware settings. For this model, the principal parameters are data rate 100Gbps (2x50G), wavelength 1560.61nm,1559.79nm, rated reach 80km with EDFA and TDCM.

Ordering Information

When ordering, specify DW2-QSFP100G80-2122, DW2-QSFP100G80-2122, quantity and intended host platform. Project labels can repeat these details for receiving and asset records. Neutral labels, customer packaging and project-specific compatibility review are available on request.

Shipping and Lead Time

Standard configurations normally ship within one to three working days, with production lead times confirmed for larger quantities. International courier, air freight and sea freight are available; customer courier accounts and nominated forwarders are accepted.

Quality Assurance and Packaging

Before packing, the module receives interface inspection, identification and link checks. Protective packaging avoids pressure on the connector and latch. Customer references, rack groups and project packing lists can be added for volume orders.

Frequently Asked Questions