Juniper Networks EX-SFP-10GE-CWE35-20 Compatible 10G SFP+ Transceiver Module

Product Highlights

• Compatible alternative to Juniper Networks EX-SFP-10GE-CWE35-20
• 10G connectivity at 10Gbps
• Optical wavelength: 1350nm
• Specified reach: 20km
• Duplex LC / SMF interface
• Operating temperature: 0 to 70°C (32 to 158°F)
• Factory compatibility verification and optical performance testing before shipment

Specifications

Applications and Optical Link Design

Use this module for equipment interconnection over the specified single-mode fiber plant, including enterprise backbone, campus, metro or data-center interconnect links according to its rated distance. Confirm that both ends use the same optical standard and wavelength plan, and allow for connector, splice and patch-panel loss within the stated power budget.

Before deployment, check the host port type, supported data rate and firmware requirements. The 10G interface configuration must match the remote equipment; sharing a SFP+ housing alone does not make two transceiver types interoperable.

For this 1350nm interface, verify channel spacing and filter compatibility. Passive filters add loss even without active equipment, so assess 20km using the complete channel rather than fiber distance alone.

Juniper Networks Compatibility and Factory Testing

Compatibility testing for EX-SFP-10GE-CWE35-20 combines identification with a live link and available transmit, receive and alarm information. Connector condition is inspected separately. Equipment model, hardware revision and software release can be reviewed before dispatch where platform behavior is uncertain.

Optical Acceptance, Diagnostics and Handling

For this model, the specified transmit-power range is 1~6dBm; receiver sensitivity is <-14.4dBm. A sound acceptance record includes link state, diagnostic temperature, supply voltage and transmit or receive levels where the host exposes them. Compare the readings with the stated ranges rather than treating any received light as proof of adequate margin. Persistent alarms or borderline values should trigger an end-face and complete-channel inspection. Before every insertion, keep dust caps in place until the patch lead is ready, avoid touching the optical end face and use an appropriate inspection and cleaning procedure. Do not look into an active optical interface.

Interoperability and Host Configuration

Check three layers before deployment: host acceptance of the module identity, port support for the stated rate, and a matching optical standard at the remote interface. For breakout operation, confirm lane configuration too. Similar-looking cages can behave differently across speeds and firmware settings. For this model, the principal parameters are data rate 10Gbps, wavelength 1350nm, rated reach 20km.

Ordering Information

Quote HT part number EX-SFP-10GE-CWE35-20 together with OEM reference EX-SFP-10GE-CWE35-20 and quantity. Add the host model and software release when pre-order verification is required. Neutral labels, customer packaging and project-specific compatibility review are available on request.

Shipping and Lead Time

Standard configurations normally ship within one to three working days, with production lead times confirmed for larger quantities. International courier, air freight and sea freight are available; customer courier accounts and nominated forwarders are accepted.

Quality Assurance and Packaging

Quality control covers the optical or electrical interface, host identification and operating link. The verified unit is then individually protected and cartoned. Customer references, rack groups and project packing lists can be added for volume orders.

Frequently Asked Questions