LC UPC to LC UPC Duplex Standard Clip Uniboot OM3 Fiber Patch Cable

Projects in the Philippines benefit from keeping the configuration, branch identification and installation requirement consistent across every participating site. This OM3 fiber patch cable carries a LC UPC interface on one end and a LC UPC interface on the other, factory terminated on OM3 glass and optically tested as a complete item. The uniboot design places both fibers of the duplex optical path inside a single round 2.0mm cord with one combined connector housing, halving the fiber cable count in space-efficient panels and simplifying polarity management.

Product Highlights

• Uniboot Allows One Cable to Carry Two Fibers to Reduce Cable Congestion in High-Density Patch Fields
• Bend Insensitive Fiber with 7.5mm Min. Bend Radius
• Termination Is Tested to Ensure Network Performance
• Designed for High-Density Fiber Cabling in Network Cabinet Connections, Ceiling Wiring and Under-Floor Wiring in a Data Center
• Support for Various Transmission Speed Ethernet Applications

Specifications

Keeping multimode links healthy

Multimode links fail more typically from contamination than from fiber damage. Every ferrule should ideally be inspected and cleaned before the interfaces are joined, and the dust caps should stay on until the moment of joint. These habits matter more than any specification on the datasheet.

OM3 for existing multimode plants

This OM3 item matches the installed base of OM3 optical path cabling: 10G links to 300 meters and 40/100G SR4 links to 70 meters. When the permanent optical path is OM3, patching with OM3 keeps the optical path specification homogeneous and the test reports clean.

Polarity without re-terminating

Uniboot connectors expose the polarity through the housing rather than the termination: the latches or clips let the installer swap the fiber positions without opening the cord. A polarity mistake discovered at turn-up becomes a two-minute correction instead of a replacement order. Project teams in the Philippines can carry this requirement into the site documentation used by each contractor.

Length Options

Standard size options cover the common patching routes: 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), with customized length provided beyond the list. Specifying the measured channel length keeps the slack out of the manager and the strain off the mating connectors.

Quality Control and Testing

Each completed assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on each cable, and end-face geometry is inspected for consistent physical contact. The fiber cable ships with dust caps on both connectors and the test result provided on order.

Ordering and Factory Support

Refer to this design by connector pair, fiber mode and length when submitting a request for a quotation. For configurations outside the listed options, mixed connector families, jackets, labeling or project packaging, send the need with the inquiry and the factory will validate the build before release to production. Customers in the Philippines can include multi-site labeling or documentation requirements when requesting a project quotation.