Cisco QDD-DR8-800G Compatible 800G QSFP-DD DR8 Transceiver Module 500m

Product Highlights

• Compatible alternative to Cisco QDD-DR8-800G
• 800G connectivity at 850Gbps (8x 106.25Gbps)
• Optical wavelength: 1310nm
• Specified reach: 500m
• MTP/MPO-16 APC / SMF interface
• Digital diagnostic monitoring: Supported
• Operating temperature: 0 to 70°C (32 to 158°F)

Specifications

Applications and Optical Link Design

Use this module for equipment interconnection over the specified single-mode fiber plant, including enterprise backbone, campus, metro or data-center interconnect links according to its rated distance. Confirm that both ends use the same optical standard and wavelength plan, and allow for connector, splice and patch-panel loss within the stated power budget.

Before deployment, check the host port type, supported data rate and firmware requirements. The 800G interface configuration must match the remote equipment; sharing a QSFP-DD housing alone does not make two transceiver types interoperable.

The single-mode link budget should include fiber attenuation, connectors, splices and panels over the intended 500m route. Keep the MTP/MPO-16 APC interface clean and match the remote optical standard. Consider receiver overload as well as insufficient power on short links.

Cisco Compatibility and Factory Testing

Factory verification starts with the expected QDD-DR8-800G identity and finishes with an operating host link. EEPROM data, diagnostic visibility and the stated optical parameters are assessed together. Equipment model, hardware revision and software release can be reviewed before dispatch where platform behavior is uncertain.

Optical Acceptance, Diagnostics and Handling

For this model, the specified transmit-power range is -2.9~4.0dBm; the stated optical power budget is 3dB. During commissioning, record the host diagnostic readings after the link has stabilized and compare them with those limits. DOM values are useful operational indicators, but they do not replace calibrated optical measurements when a link is marginal. Investigate unexpected loss through connector inspection, cleaning and a channel measurement before replacing the module. Diagnostic monitoring is listed as Supported. Before every insertion, keep dust caps in place until the patch lead is ready, avoid touching the optical end face and use an appropriate inspection and cleaning procedure. Do not look into an active optical interface.

Interoperability and Host Configuration

Check three layers before deployment: host acceptance of the module identity, port support for the stated rate, and a matching optical standard at the remote interface. For breakout operation, confirm lane configuration too. Similar-looking cages can behave differently across speeds and firmware settings. For this model, the principal parameters are data rate 850Gbps (8x 106.25Gbps), wavelength 1310nm, rated reach 500m.

Ordering Information

Quote HT part number QDD-DR8-800G together with OEM reference QDD-DR8-800G and quantity. Add the host model and software release when pre-order verification is required. Neutral labels, customer packaging and project-specific compatibility review are available on request.

Shipping and Lead Time

Standard configurations normally ship within one to three working days, with production lead times confirmed for larger quantities. International courier, air freight and sea freight are available; customer courier accounts and nominated forwarders are accepted.

Quality Assurance and Packaging

Before packing, the module receives interface inspection, identification and link checks. Protective packaging avoids pressure on the connector and latch. Customer references, rack groups and project packing lists can be added for volume orders.

Frequently Asked Questions