Juniper Networks SFPP-10GE-BX10D-IT Compatible 10G SFP+ BX10-D Transceiver Module 10km

Product Highlights

• Compatible alternative to Juniper Networks SFPP-10GE-BX10D-IT
• 10G connectivity at 11.3168Gbps
• Optical wavelength: 1330nm-TX/1270nm-RX
• Specified reach: 10km
• Simplex LC / SMF interface
• Operating temperature: 0 to 70°C (32 to 158°F)
• Factory compatibility verification and optical performance testing before shipment

Specifications

Applications and Optical Link Design

This BiDi interface is useful where only one fiber strand is available between two sites or racks. It must be paired with the complementary wavelength direction: one end transmits on the wavelength that the other end receives. Verify the paired part number, connector polish and fiber plant before installation, and measure link loss against the specified optical budget.

Before deployment, check the host port type, supported data rate and firmware requirements. The 10G interface configuration must match the remote equipment; sharing a SFP+ housing alone does not make two transceiver types interoperable.

BiDi operation saves a fiber strand but makes wavelength orientation critical. Record the part installed at each end and check its paired receive wavelength. The 10km rating still depends on total channel loss, including connectors and splices.

Juniper Networks Compatibility and Factory Testing

Factory verification starts with the expected SFPP-10GE-BX10D-IT identity and finishes with an operating host link. EEPROM data, diagnostic visibility and the stated optical parameters are assessed together. Equipment model, hardware revision and software release can be reviewed before dispatch where platform behavior is uncertain.

Optical Acceptance, Diagnostics and Handling

For this model, the specified transmit-power range is -6.5~0.5dBm; receiver sensitivity is < -14.4dBm. Digital diagnostics make later maintenance easier when baseline values are captured at installation. Save the initial readings with the port and OEM reference, then investigate meaningful changes rather than reacting to a single transient value. Diagnostic support depends on the host as well as the module, so unavailable fields should be confirmed with the platform documentation. Before every insertion, keep dust caps in place until the patch lead is ready, avoid touching the optical end face and use an appropriate inspection and cleaning procedure. Do not look into an active optical interface.

Interoperability and Host Configuration

Check three layers before deployment: host acceptance of the module identity, port support for the stated rate, and a matching optical standard at the remote interface. For breakout operation, confirm lane configuration too. Similar-looking cages can behave differently across speeds and firmware settings. For this model, the principal parameters are data rate 11.3168Gbps, wavelength 1330nm-TX/1270nm-RX, rated reach 10km.

Ordering Information

When ordering, specify SFPP-10GE-BX10D-IT, SFP-10G32-BX10, quantity and intended host platform. Project labels can repeat these details for receiving and asset records. Neutral labels, customer packaging and project-specific compatibility review are available on request.

Shipping and Lead Time

Standard configurations normally ship within one to three working days, with production lead times confirmed for larger quantities. International courier, air freight and sea freight are available; customer courier accounts and nominated forwarders are accepted.

Quality Assurance and Packaging

Quality control covers the optical or electrical interface, host identification and operating link. The verified unit is then individually protected and cartoned. Customer references, rack groups and project packing lists can be added for volume orders.

Frequently Asked Questions