MMC to MMC 1-Port Fiber Optic Adapter/Coupler without Flange

Projects in the Philippines benefit from keeping the configuration, branch identification and installation requirement consistent across every participating site. This one-port MMC-to-MMC adapter gives a single mating mounting point in a compact green plastic body. The reduced-flange design measures 12.9 x 5.8 x 29.6mm and is meant for compatible MMC panel cut-outs. It offers a simple building block for custom faceplates, enclosures and low-count MMC patching positions.

Product Highlights

• Connector Type: MMC-MMC
• Body Style: 1-Port
• Color: Green
• Mounting Type: Reduced Flanged
• Body Material: Plastic
• Dimensions (HxWxD): 12.9x5.8x29.6mm

Specifications

A single position for custom panel layouts

The one-port body is useful where only one MMC joint is applicable or where positions should be spaced individually across a faceplate. It avoids committing panel space to a multi-port block. inspect the cut-out against the 5.8mm body width and 12.9mm height, and validate that the reduced-flange mounting style matches the enclosure design before fabrication.

Alignment, gender and polish are separate checks

This coupler aligns two MMC connectors but is not intended to change connector gender, fiber count or polish. Establish that the two cable or device interfaces are intended to mate and that their guide-pin arrangement is right. Use matching polish types and keep the mounting point dust-capped when empty; an adapter cannot compensate for a contaminated or damaged ferrule.

Installation and maintenance access

Leave adequate space in front of this coupler for the push-pull boot and adequate space behind it for cable bend radius. A single connector in a dense panel may still be difficult to remove if adjacent cabling blocks the boot. Review and clean both MMC end faces before the interfaces are joined, and avoid using this coupler body as a cable support point.

Ordering and Factory Support

Reference part number 24925 for the one-port reduced-flange adapter. State unit count and, if it will be installed in a custom panel, give the cut-out layout or a sample panel need so mounting compatibility may readily be reviewed. Customers in the Philippines can include multi-site labeling or documentation requirements when requesting a project quotation.